Array Support Library (ASL)/Array Policy Module (APM) Details
VRTSNIPNYis [Download] - 475 K Sign in if you want to rate this ASL/APM.

 Basic information

Library name: libvxnipnyis
Library version: 5.0-rev-1
Package name: VRTSNIPNYis
Package version: 5.0-rev-1
Supported product versions:
  • 5.0MP2
  • 5.0MP1
  • 5.0
Embedded in VxVM?: No
Supported platforms:
  • HP-UX 11i v2 (11.23)
TechNote: 293836
Popularity: 598 viewed  5 downloaded
Download size: 475K
Checksum: 59990550
Release date: N/A

 Supported Arrays and Modes

  • iStorage D3 series, iStorage D3-10, iStorage D3-30, iStorage D4-30, iStorage S1000 series, iStorage S1100, iStorage S1300, iStorage S1400, iStorage S1500, iStorage S2000 series, iStorage S2100, iStorage S2300, iStorage S2400, iStorage S2500, iStorage S2800, iStorage S2900, iStorage S4000 series, iStorage S4100, iStorage S4300, iStorage S4900
Supported mode: A/A

 Readme file  [Save As...]

This TechFile provides information about the Array Support Library (ASL) for NEC iStorage S1000/S2000/S4000 Series and D Series Arrays on Veritas Volume Manager 5.0 and later for HP-UX 11iv2. For general information about ASLs, refer to TechNote 249446 (link in the Related Documents section of this TechFile). Package Name: VRTSNIPNYis Package Version: 5.0-rev-1 Supported versions of Veritas Volume Manager: 5.0 and later Supported Arrays: NEC iStorage S1000/S2000/S4000 Series and D Series Array (Active/Active) 1. Create a directory to store the ASL package: # mkdir /tmp/asl 2. At the bottom of this TechFile, click on Download Now to download the ASL package 3. Download the file VRTSNIPNYis_v1_HPUX_50_293836.tar.Z into the /tmp/asl directory 4. Before adding any ASL packages, ensure Veritas Volume Manager is installed and enabled: # vxdctl mode mode: enabled INSTALLATION INSTRUCTIONS 1. To install the package: # cd /tmp/asl # zcat VRTSNIPNYis_v1_HPUX_50_293836.tar.Z | tar xvf - # swinstall -s `pwd` VRTSNIPNYis 2. After the package is installed, you must execute the vxdctl enable command to claim the disk array as an NEC iStorage array: # vxdctl enable 3. After executing vxdctl enable, you should see in the output of the vxddladm listsupport command: # vxddladm listsupport all LIBNAME VID ============================================================================== ... NEC # vxddladm listsupport ATTR_NAME ATTR_VALUE ======================================================================= LIBNAME VID NEC PID iStorage 1000, iStorage 2000, iStorage 4000 ARRAY_TYPE A/A ARRAY_NAME NEC Note: If Veritas Volume Manager (tm) 5.0 is updated from 4.1, the output of vxdisk list may show udid_mismatch. Please do not execute the vxdisk updateudid command to erase udid_mismatch at this time. If you would like to erase udid_mismatch, please do a full backup of all relevant data on disk groups, and restore them after rebuild the disk group.