This TechFile provides information about the Array Support Library for 3PAR InServ Storage Servers (Active/Active) on Veritas Volume Manager (tm) 5.0 and later for Solaris Opteron (x64). For general information about ASLs, see TechNote 249446 http://support.veritas.com/docs/249446 Package Name: VRTS3par Package Version: 5.0,REV=03.13.2007.11.47 Supported versions of Veritas Volume Manager: 5.0 and later Supported Arrays: 3PAR InServ S400/S800 (Active/Active) Installation Instructions: 1. Create a directory to store ASL package: # mkdir /tmp/asl 2. At the bottom of this TechFile, click on Download Now to download the package 3. Download the file VRTS3par_5.0_sol_i386_v1_290637.tar.Z into /tmp/asl directory and verify the cksum # cksum VRTS3par_5.0_sol_i386_v1_290637.tar.Z 2733936874 9874 VRTS3par_5.0_sol_i386_v1.tar.Z 4. Before adding any ASL package, ensure Veritas Volume Manager is installed and enabled: # vxdctl mode mode: enabled 5. To install the package: # cd /tmp/asl # zcat VRTS3par_5.0_sol_i386_v1_290637.tar.Z | tar xvf - # pkgadd -d . VRTS3par After the package is installed, you must run the vxdctl enable command to claim the disk array as a 3PAR array: # vxdctl enable The pkginfo of the package installed: # pkginfo -l VRTS3par PKGINST: VRTS3par NAME: Array Support Library for 3PARdata Arrays CATEGORY: system ARCH: i386 VERSION: 5.0,REV=03.13.2007.11.47 BASEDIR: /etc/vx VENDOR: VERITAS Software DESC: Array Support library for 3PARdata Arrays PSTAMP: VERSION-5.0:March-2007 INSTDATE: Aug 15 2007 12:23 HOTLINE: 800-342-0652 EMAIL: support@veritas.com STATUS: completely installed FILES: 5 installed pathnames 3 shared pathnames 3 directories 2 executables 16 blocks used (approx) After running the vxdctl enable command, you should see libvx3par.so in the output of the vxddladm listsupport command: # vxddladm listsupport libname=libvx3par.so ATTR_NAME ATTR_VALUE ======================================================================= LIBNAME libvx3par.so VID 3PARdata PID VV ARRAY_TYPE A/A ARRAY_NAME 3PARDATA