Preparing Data Insight for FPolicy in NetApp Cluster-Mode

The Symantec Data Insight FPolicy server is represented by DataInsightFpolicyCmod service which runs on each Collector worker node. Before you assign a Data Insight server as a Collector for a clustered NetApp filer, you must configure the Cluster-Mode FPolicy service on that server.

To configure the DataInsightFPolicyCmod service

  1. Provision a Windows 2003 or 2008 server. Symantec recommends a minimum requirement of a Windows 2008 64-bit server with 4 to 8GB RAM and a quad core processor. A higher configuration may be required if the load on the FPolicy server is high.

    This computer hosts the FPolicy server.

  2. Install the Data Insight Collector worker node or the Data Insight Management Server on this server.
  3. Log in to the Data Insight Management Console.
  4. In the Console, click Settings > Data Insight Servers to open the listing page for the server.
  5. Select the server that is configured to monitor the NetApp clustered file server to open the details page for the server.
  6. Click the Services tab.
  7. Select DataInsightFPolicyCmod to expand the section.
  8. To configure the service, enter the following details:
    • The user-configured name to create FPolicy the ONTAP cluster.

    • The IP address of the Data Insight Collector running the FPolicy server.

      The NetApp ONTAP Cluster-Mode filer connects with the DataInsightFPolicyCmod service running on the Data Insight Collector node on this IP address.

    • The TCP port used on the DataInsightCollector server.

      The NetApp ONTAP Cluster-Mode filer connects on this port to the Data Insight Collector. Ensure that this port is not blocked by firewall.

  9. Click Configure.

More Information

Configuring Data Insight services