Troubleshooting discovery of assets

When asset infrastructure is added to the Infrastructure Management Server (IMS), or when changes are made to the infrastructure, the IMS discovers and correlates the asset information and displays the information on the Assets page of the Resiliency Platform console. The discovery can take some time before the information is updated on the console. Until discovery is complete, some information needed to configure resiliency groups may be missing from the Assets page on the console.

See About the frequency of asset information discovery.

If changes have been made to the asset infrastructure, you can use the Refresh operation on assets in the IMS to speed up discovery so that updated asset information is displayed more quickly in the console. To use the Refresh operation, display the asset infrastructure page for the IMS, select the asset type, right-click the asset and select Refresh.

If you are configuring replication using storage arrays in a VMware vCenter Server environment, you can use the following guidelines to speed up discovery or to troubleshoot information that is not being updated:

Table: Configuring asset infrastructure in IMS for storage arrays in VMware environment

Situation

Troubleshooting/best practices

Adding storage arrays as enclosures to IMS

Ensure that the storage arrays that are added to the IMS are the ones that provide storage to the ESX servers managed by the vCenter Server that is added to the IMS.

More than one IMS in data center

Ensure that the vCenter Server that is managing the ESX servers, and the enclosure providing storage to those servers, are added to the same IMS.

Refreshing the IMS after a change in infrastructure

Ensure that you use the Refresh operation on the correct vCenter Servers and enclosures where the change was made.

Refreshing the IMS after a change in infrastructure, where there is more than one IMS

Ensure that you use the Refresh operation in the correct IMS.

In the VMware and EMC SRDF environment, the general guideline is to add/refresh the enclosure before adding/refreshing the VMware vCenter Server.

Table: Configuring or refreshing asset infrastructure in IMS for VMware and EMC SRDF environment

Situation

Recommended sequence

You have not yet added the asset infrastructure.

Add the enclosure information in the IMS and let the discovery complete before adding the vCenter Server to the IMS.

You later provision new storage from an enclosure that is already configured in the IMS and mount datastores from the new storage.

Refresh the enclosure in the IMS, let the refresh task on the enclosure complete, and then refresh the vCenter Server in the IMS.

You provision storage from a new enclosure.

Add the new enclosure in the IMS and then refresh the vCenter Server after the enclosure discovery completes.

You are provisioning storage from an enclosure that is already configured in the IMS to new ESX servers managed by a vCenter Server.

Refresh the enclosure first, than add the vCenter Server to the IMS or refresh it if it is already added to the IMS.

In the VMware and NetApp SnapMirror environment, the general guideline is add/refresh the vCenter Server first, then add/refresh the NetApp enclosure.

Table: Configuring or refreshing asset infrastructure in IMS for storage arrays in VMware and NetApp SnapMirror environment

Situation

Recommended sequence

You have not yet added the asset infrastructure.

Add the vCenter Server to the IMS first and let the discovery complete before you add the NetApp enclosure.

You later provision storage from an existing NetApp enclosure and mount NFS datastores on ESX servers.

Refresh the vCenter Server first in the IMS, let the discovery complete and then refresh the NetApp enclosure.

You later provision storage from a new NetApp enclosure and mount NFS datastores on that ESX servers.

Refresh the vCenter Server first in the IMS, wait for the vCenter Server discovery to complete, and then add the new NetApp enclosure.

The recommended sequence for adding or modifying asset infrastructure for application discovery in the NetApp SnapMirror replication environment is as follows: Ensure that discovery of the hosts is complete before you add or refresh the NetApp enclosures.

More Information

Adding the asset infrastructure to an Infrastructure Management Server (IMS)