To modify resiliency group information

1. Prerequisites

   • After you configure a resiliency group for disaster recovery, you cannot edit the resiliency group. You must first unconfigure disaster recovery for the resiliency group, edit it, and then configure disaster recovery again.

   • Determine the potential impact modifying the resiliency group may have on users. If necessary, notify users of the upcoming change.

2. Navigate

   Assets > Resiliency Groups tab

3. Select

   Use the on-screen filters, Search field, and table heading sort feature to locate your resiliency group.

4. Edit

   Do one of the following:

   • Right click on the resiliency group row and select Modify.

   • On the right side of the resiliency group row, click on the vertical ellipsis and select Modify.

   The steps for editing the resiliency group are the same as creating it.

   When you edit a resiliency group made up of virtual machines, note the following:

   • If the resiliency group is configured for disaster recovery, Resiliency Platform proceeds to the Protect VM wizard.

   • When the number of virtual machines on the replicated volume changes, edit the resiliency group to add or remove the virtual machines.

   Note:

   If you add or remove virtual machines from a resiliency group after you have configured DR for that particular resiliency group, the DR functionality may not work as expected. You need to reconfigure DR for the resiliency group with the current set of virtual machines.