Specifying systems for configuration
The installer prompts for the system names on which you want to configure VCS. The installer performs an initial check on the systems that you specify.
To specify system names for installation
Enter the names of the systems where you want to configure VCS.
Enter the system names separated by spaces on which to configure
VCS: galaxy nebula
Review the output as the installer verifies the systems you specify.
The installer does the following tasks:
Checks that the local node running the installer can communicate with remote nodes
If the installer finds ssh binaries, it confirms that ssh can operate without requests for passwords or passphrases.
Makes sure the systems use the proper operating system
Checks whether VCS is installed
Exits if VCS 5.0.1 is not installed