Creating a Replicated Data Set


Creating a Replicated Data Set
Prev	Setting up replication	Next

To create a Replicated Data Set (RDS), perform the following tasks in the order presented below:

Create a Primary Replicated Volume Group (RVG) of the RDS

You can also associate volume-set component volumes to an RDS.

See Associating a volume set to an RDS.
Add a Secondary to the RDS
Change the Replication Settings for the Secondary

In a shared disk group environment, commands must be issued from the CVM master. However, the RLINK informational and administrative commands, vxrlink pause, vxrlink resume, vxrlink status, and vxrlink stats can be issued on any node in the cluster.

Prev	Up	Next
Best practices for setting up replication	Home	Creating a Primary RVG of an RDS