Use the Add Bunker wizard to add a bunker Secondary to the RDS. After adding the bunker Secondary, you can proceed with synchronizing the Secondary and starting replication.
See Synchronizing the Secondary and starting replication using VVR VEA.
To add a bunker Secondary to the RDS
From the tree view, select the name of the Primary for which you want to create the bunker Secondary. For example, hr_rvg.
Choose Replication > Add Bunker. To use the pop-up menu, right-click the name of the Primary, for example, seattle. The Add Bunker wizard is displayed.
Complete the Add Bunker wizard page as follows:
In the next page, the message indicates the result of the add bunker operation. If the operation of adding the bunker Secondary was successful the page displays a success message.
If the operation fails, the page displays the failure message and lists the possible reasons of failure in the Result Details area. Read the details carefully and take appropriate corrective action. For more information about the error, note down the Unique Message Identifier (UMI) that is displayed with the error message, and then refer the Veritas Technical Services knowledge base.
Click Finish. The Add Bunker wizard sets the same default values that are set by the Add Secondary wizard.