Note: |
The Remote Mirror feature requires that the Site Awareness license has been installed on all hosts at all sites that participate in the configuration. |
This section describes setting up a new disk group. To configure an existing disk group as a Remote Mirror configuration, additional steps may be required.
See Making an existing disk group site consistent.
Setting up a new disk group for a Remote Mirror configuration requires the following steps:
Define the site name for each host that can access the disk group.
Set up automatic site tagging for the disk group, if required.
Assign a site name to the disks or enclosures. You can set site tags at the disk level or at the enclosure level. If you specify one or more enclosures, the site tag applies to the disks in that enclosure that are within the disk group.