|
|
|
|
|
Chapter 1 Overview of CDS
Chapter 2 Setting up your system
Creating CDS disks from uninitialized disks
Creating CDS disks from initialized VxVM disks
Creating a CDS disk from a disk that is not in a disk group
Creating a CDS disk from a disk that is already in a disk group
Converting non-CDS disks to CDS disks
Chapter 3 Maintaining your system
Changing the alignment of a disk group during disk encapsulation
Changing the alignment of a non-CDS disk group
Moving objects between CDS disk groups and non-CDS disk groups
Moving objects between CDS disk groups
Changing the default CDS setting for disk group creation
Upgrading an older version non-CDS disk group
Replacing a disk in a CDS disk group
Setting the maximum number of devices for CDS disk groups
Changing the DRL map and log size
Determining the setting of the CDS attribute on a disk group
Displaying the maximum number of devices in a CDS disk group
Displaying map length and map alignment of traditional DRL logs
Displaying the disk group alignment
Displaying the log map length and alignment
Displaying offset and length information in units of 512 bytes
Chapter 4 File system data sharing
Considerations about data in the file system
Specifying the migration target
Checking that the metadata limits are not exceeded
Maintaining the list of target operating systems
Enforcing the established CDS limits on a file system
Ignoring the established CDS limits on a file system
Migrating a file system one time
Appendix A Transferring data between platforms
Alignment value and block size
Default activation mode of shared disk groups
Disk group alignment and encapsulated disks
Appendix B Error codes and error recovery