< Previous  | TOC | Index | Next  >  

V-5-0-113 

Disconnecting rep rlink_name to shift to DCM protection 

This indicates a temporary disconnect during shifting to DCM protection.  

V-5-0-149 

Encountered IBC while flushing SRL to DCM - IBC dropped 

The IBC residing on the SRL will be dropped when DCM protection gets triggered. You need to reissue the IBC after the DCM replay completes. 

V-5-0-265 

Rlink rlink_name connected to remote 

The named RLINK has succeeded in connecting to its remote RLINK. 

V-5-0-266 

Rlink rlink_name disconnected from remote 

The named RLINK has disconnected from its remote RLINK. This can have many different causes, including: 

• The network is down
• The Secondary node is down
• The Primary RLINK was paused or detached
• The Secondary RLINK was detached

The RLINK will connect automatically when the situation clears. 

V-5-0-270 

Rlink rlink_name has a Secondary config error 

Indicates different states of the specified RLINK. 

V-5-0-271 

Rlink rlink_name has a Secondary log error 

V-5-0-274 

Rlink rlink_name is in failed state 

V-5-0-275 

Rlink rlink_name is inconsistent 

V-5-0-276 

Rlink rlink_name is primary paused 

V-5-0-277 

Rlink rlink_name is Secondary paused 

V-5-0-278 

Rlink rlink_name is stale and not replicating 

V-5-0-330 

Unable to connect to rlink rlink_name on rvg rvg_name: Time out on remote 

The Secondary machine is unreachable. Will clear up when the network or the Secondary node recovers. 

V-5-0-467 

Paused replay on RVG rvg_name  

The DCM replay gets paused on Primary. This can have many different causes, including: 

• The network is down
• The Secondary node is down
• The Primary RLINK was paused or detached.
• The Secondary RLINK was paused or detached.

DCM replay will start automatically when the RLINK gets connected. 

V-5-0-0 

Disconnecting rlink rlink_name due to kernel reset 

This may happen due to a user initiated action, which causes the kernel objects to be recreated. 

V-5-0-0 

Disconnecting rlink rlink_name to permit transaction to proceed 

The RLINK may get temporarily disconnected if a transaction is in progress. Once the transactions is completed, the RLINK will get reconnected. 

V-5-0-79 

cannot recover vol vol_name 

During a reboot, the specified data volume was found to be disabled, and so cannot be recovered properly. The data volume may no longer be considered valid. 

V-5-0-101 

DCM replay complete on rlink rlink_name 

DCM replay gets completed on the specified RLINK. 

V-5-3-0 

Resumed replay on RVG rvg_name 

DCM replay gets resumed on the Primary. DCM replay will start automatically when the RLINK gets connected. 

 ^ Return to Top

< Previous  | TOC | Index | Next  >