Symantec logo

Traditional third-mirror break-off snapshots

Third-mirror snapshot creation and usage shows the traditional third-mirror break-off volume snapshot model that is supported by the vxassist command.

Third-mirror snapshot creation and usage

Third-mirror snapshot creation and usage

Click the thumbnail above to view full-sized image.

The vxassist snapstart command creates a mirror to be used for the snapshot, and attaches it to the volume as a snapshot mirror. (The vxassist snapabort command can be used to cancel this operation and remove the snapshot mirror.)

As is usual when creating a mirror, the process of copying the volume's contents to the new snapshot plexes can take some time to complete. Full-sized and space-optimized instant snapshots can be used to make snapshots immediately available.

See "Full-sized instant snapshots" on page 291.

See "Space-optimized instant snapshots" on page 293.

When the attachment is complete, the vxassist snapshot command is used to create a new snapshot volume by taking one or more snapshot mirrors to use as its data plexes. The snapshot volume contains a copy of the original volume's data at the time that you took the snapshot. If more than one snapshot mirror is used, the snapshot volume is itself mirrored.

The command, vxassist snapback, can be used to return snapshot plexes to the original volume from which they were snapped, and to resynchronize the data in the snapshot mirrors from the data in the original volume. This enables you to refresh the data in a snapshot after each time that you use it to make a backup. You can also use a variation of the same command to restore the contents of the original volume from a snapshot that you took at an earlier point in time.

See "Restoring the original volume from a snapshot" on page 300.

You can use the FastResync feature of VxVM to minimize the time needed to resynchronize the data in the snapshot mirror. If FastResync is not enabled, a full resynchronization of the data is required.

See "FastResync" on page 65.

Finally, you can use the vxassist snapclear command to break the association between the original volume and the snapshot volume. The snapshot volume then has an existence that is independent of the original volume. This is useful for applications that do not require the snapshot to be resynchronized with the original volume.

The use of the vxassist command to administer traditional (third-mirror break-off) snapshots is not supported for volumes that are prepared for instant snapshot creation. The vxsnap command may be used instead.

See "Full-sized instant snapshots" on page 291.

See "Creating traditional third-mirror break-off snapshots" on page 330.