|
|
|
|
|
To disable DRL (configured using a version 20 DCO volume) on a volume
# vxvol [-g diskgroup] set drl=off volume
To re-enable DRL on a volume, enter this command:
# vxvol [-g diskgroup] set drl=on volume
To re-enable sequential DRL on a volume, enter:
# vxvol [-g diskgroup] set drl=sequential volume
You can use these commands to change the DRL policy on a volume by first disabling and then re-enabling DRL as required. DRL is automatically disabled if a data change map (DCM, used with Veritas Volume Replicator) is attached to a volume.