This section show state transition diagrams with respect to the ResFaultPolicy
attribute.
By default, the ResFaultPolicy
attribute is set to FaultPropagateAll, in which case the agent calls the clean
entry point. Based on the value of the resource type level attribute RestartLimit
, the agent attempts to restart the resource before declaring it as FAULTED. In general, when ResFaultPolicy attribute is set to FaultHold, the bdhavior is the same as when it is set to FaultPropagateAll. Further actions depend on the group level attribute GrpFaultPolicy
.
The next set of diagrams illustrate the following state transitions:
ResFaultPolicy
set to FaultNone
ResFaultPolicy
set to FaultNone
ResFaultPolicy
set to FaultPropagateAll or FaultHold
offline
), ResFaultPolicy
set to FaultNone
monitor
hung), ResFaultPolicy
set to FaultPropagateAll
monitor
hung), ResFaultPolicy
set to FaultNone