VVR VEA enables you to set up Volume Replicator (VVR) configurations on participating hosts from a remote client. VVR enables you to set up replication either when the data volumes are zero initialized or contain valid data, and when the application is active or stopped.
Before setting up a Replicated Data Set, lay out your VVR configuration using the Configuration Worksheet in the Veritas Volume Replicator Installation Guide. Follow the best practices or recommendations listed in Best practices for setting up replication to ensure successful configuration of VVR. You can set up replication using one of the following procedures:
Setting up replication using the create RDS wizard
Setting up replication using individual tasks
The Create Replicated Data Set wizard guides you through the process of setting up replication using automatic synchronization. For instructions on setting up replication using the Create Replicated Data Set wizard, see Setting up replication using the create RDS wizard. For instructions on setting up replication using separate tasks, see Setting up replication using individual tasks.