Symantec logo

Volume states

Volume states shows the volume states that may be displayed by VxVM commands such as vxprint.

Volume states

Volume state

Description

ACTIVE 

The volume has been started (kernel state is currently ENABLED) or was in use (kernel state was ENABLED) when the machine was rebooted. 

If the volume is currently ENABLED, the state of its plexes at any moment is not certain (since the volume is in use). If the volume is currently DISABLED, this means that the plexes cannot be guaranteed to be consistent, but are made consistent when the volume is started.  

For a RAID-5 volume, if the volume is currently DISABLED, parity cannot be guaranteed to be synchronized.  

CLEAN 

The volume is not started (kernel state is DISABLED) and its plexes are synchronized. For a RAID-5 volume, its plex stripes are consistent and its parity is good. 

EMPTY 

The volume contents are not initialized. The kernel state is always DISABLED when the volume is EMPTY.  

INVALID 

The contents of an instant snapshot volume no longer represent a true point-in-time image of the original volume. 

NEEDSYNC 

The volume requires a resynchronization operation the next time it is started. For a RAID-5 volume, a parity resynchronization operation is required. 

REPLAY 

The volume is in a transient state as part of a log replay. A log replay occurs when it becomes necessary to use logged parity and data. This state is only applied to RAID-5 volumes. 

SYNC 

The volume is either in read-writeback recovery mode (kernel state is currently ENABLED) or was in read-writeback mode when the machine was rebooted (kernel state is DISABLED). With read-writeback recovery, plex consistency is recovered by reading data from blocks of one plex and writing the data to all other writable plexes. If the volume is ENABLED, this means that the plexes are being resynchronized through the read-writeback recovery. If the volume is DISABLED, it means that the plexes were being resynchronized through read-writeback when the machine rebooted and therefore still need to be synchronized.  

For a RAID-5 volume, the volume is either undergoing a parity resynchronization (kernel state is currently ENABLED) or was having its parity resynchronized when the machine was rebooted (kernel state is DISABLED).  

The interpretation of these states during volume startup is modified by the persistent state log for the volume (for example, the DIRTY/CLEAN flag). If the clean flag is set, an ACTIVE volume was not written to by any processes or was not even open at the time of the reboot; therefore, it can be considered CLEAN. The clean flag is always set in any case where the volume is marked CLEAN.