|
|
|
|
|
fsvmap - map volumes of VxFS file systems to files
fsvmap [ -mdv ] [ -c checkpoint | -C ] mount_point_or_vset [ volume ... ]
The fsvmap command was introduced to verify Dynamic Storage Tiering allocation policies.
The fsvmap command maps one or more volumes to the files that have extents on those volumes. By default, the output is limited to the default fileset.
The fsvmap command can report information on disabled volumes, as long as those volumes contain no metadata. That is, the volumes must be dataonly. See the fsvoladm(1m) manual page for information on dataonly volumes. The information on disabled volumes can be used to determine which files are or would be affected by the loss of a dataonly volume, both before and after the volume is lost.
The fsvmap command only operates on VxFS multi-volume file systems.
The fsvmap command considers extents for any extended attribute inodes to be associated with the file that owns those attributes.
Unprintable characters in file names are translated into a sequence of printable characters so that each file is guaranteed to be displayed on a single line. The sequence is //0xXX, where XX is a hex sequence of the character's ASCII value. Since // is not a valid sequence in a filename, the format is unambiguous. For example, in the following output:
Data UNNAMED /file with embedded//0x0anewline //0x0a represents an embedded newline character.
Use the fsmap command to report extent information for files on a VxFS file system. The functionality of fsmap is the reverse of fsvmap.
No cluster issues; command operates the same on cluster file systems.
Displays output for all Storage Checkpoints as well as the default fileset.
Limits the output to files in the specified Storage Checkpoints.
Disables the translation of unprintable characters. Each filename is printed without being translated, and is both prefixed and suffixed by // to allow detection of when the filename begins and ends. For example, a filename with a newline character displays as follows:
Data UNNAMED ///file with embedded
Reports metadata for each file.
Specifies the mount point of a file system or a file system's volume set device.
Limits the output to files on the specified volumes. If no volumes are specified, fsvmap reports information for all volumes in the file system's volume set. If only one volume is specified, the volume name is suppressed in the output. See EXAMPLES.
To report files that have extents on a single volume:
# fsvmap /dev/vx/rdsk/fstest/testvset vol1
To report files that have extents on any of multiple volumes:
# fsvmap /dev/vx/rdsk/fstest/testvset vol1 vol2
To report files from all Storage Checkpoints that have extents on a single volume:
# fsvmap -C /dev/vx/rdsk/fstest/testvset vol1
To report files that have extents, either data or metadata, on a single volume:
# fsvmap -m /dev/vx/rdsk/fstest/testvset vol1
To report files from all Storage Checkpoints that have data or metadata extents on any volume in the file system and indicate if the volume has file system metadata:
# fsvmap -mvC /dev/vx/rdsk/fstest/testvset
Meta STRUCTURAL vol1 //volume has filesystem metadata//
fsmap(1M), fsvoladm(1M), vxvset(1M)