Symantec logo

Setting the attributes of the paths to an enclosure

You can use the vxdmpadm setattr command to set the following attributes of the paths to an enclosure or disk array:

active 

Changes a standby (failover) path to an active path. The following example specifies an active path for an A/P-C disk array: 

# vxdmpadm setattr path c2t10d0s2 pathtype=active

nomanual 

Restores the original primary or secondary attributes of a path. This example restores the attributes for a path to an A/P disk array: 

# vxdmpadm setattr path c3t10d0s2 \

  pathtype=nomanual

nopreferred 

Restores the normal priority of a path. The following example restores the default priority to a path: 

# vxdmpadm setattr path c1t20d0s2 \

  pathtype=nopreferred

preferred [priority=N

Specifies a path as preferred, and optionally assigns a priority number to it. If specified, the priority number must be an integer that is greater than or equal to one. Higher priority numbers indicate that a path is able to carry a greater I/O load. 


  Note   Setting a priority for path does not change the I/O policy. The I/O policy must be set independently.


See "Specifying the I/O policy" on page 159. 

This example first sets the I/O policy to priority for an Active/Active disk array, and then specifies a preferred path with an assigned priority of 2: 

# vxdmpadm setattr enclosure enc0 \

  iopolicy=priority

# vxdmpadm setattr path c1t20d0s2 \

  pathtype=preferred priority=2

primary 

Defines a path as being the primary path for an Active/Passive disk array. The following example specifies a primary path for an A/P disk array: 

# vxdmpadm setattr path c3t10d0s2 \

  pathtype=primary

secondary 

Defines a path as being the secondary path for an Active/Passive disk array. This example specifies a secondary path for an A/P disk array: 

# vxdmpadm setattr path c4t10d0s2 \

  pathtype=secondary

standby 

Marks a standby (failover) path that it is not used for normal I/O scheduling. This path is used if there are no active paths available for I/O. The next example specifies a standby path for an A/P-C disk array: 

# vxdmpadm setattr path c2t10d0s2 \

  pathtype=standby