After you install VCS, the file /etc/gabtab contains a gabconfig(1)
command that configures the GAB driver for use.
The file /etc/gabtab contains a line that resembles:
where the -c
option configures the driver for use and -n
N
specifies that the cluster is not formed until at least N
nodes are ready to form the cluster. By default, N
is the number of nodes in the cluster.
Note
Symantec recommends not using the -c -x
option for /sbin/gabconfig
. The Gigabit Ethernet controller does not support the use of -c -x
.