Reconfiguring virtual IP address for repository configuration
Prev Managing the SFDB repository Next

Reconfiguring virtual IP address for repository configuration

When configuring a two-node cluster, use the following steps to change the virtual IP address.

To change the virtual IP address for a standalone instance:

  1. Change the IP address.

  2. Update the new IP information for SFUA repository access by running the sfua_db_config command:

    # /opt/VRTSdbcom/bin/sfua_db_config

To change the virtual IP address for a cluster environment

  1. Change the IP address for the cluster.

  2. Update the IP address for the repository configuration in HA environment by running the following set of commands.

  3. Unconfigure the SFUA repository.

    # /opt/VRTSdbcom/bin/sfua_db_config -o unconfig_cluster

  4. Import the repository disk group.

  5. Start the repository disk volume.

  6. Mount the repository file system.

  7. Run the following command.

    # /opt/VRTSdbcom/bin/sfua_db_config

  8. When prompted, select the option to change the configuration parameters for the cluster configuration. Enter the new cluster IP address for the cluster configuration.

Prev Up Next
Adding a new system to an HA configuration Home Accessing an off-host repository in a non-VCS environment