If you are using an existing snapplan to create the clone database, some parameters are required.
To create a clone database with an existing snapplan using default settings
Access the Create Clone Database wizard.
In the Create Clone Database dialog, select create a clone database using Database FlashSnap. Click Next.
In the Database FlashSnap Clone Database dialog, select Existing Snapplan. The snapplan displays its status. For example, sp00 [init_db] /ora_home/snapplan/sp00, where INIT_DB is the status of the snapplan.
Select a snapplan from the drop-down list SNAPSHOT_END status. The Startup Snapshot Database dialog displays.
Use the dialog procedure for Startup Clone Database:
See “To start up a snapshot using the Create Clone Database wizard”.
To create a clone database with an existing snapplan using INIT_FULL
Access the Create Clone Database wizard.
In the Create Clone Database dialog, select Existing Snapplan. The snapplan displays its status. For example, sp00 [init_full] /ora_home/snapplan/sp00, where INIT_FULL is the status of the snapplan.
Select a snapplan from the drop-down list with INIT_FULL status. The Create Snapshot dialog displays.
To create a clone database with an existing snapplan using INIT_DB
Access the Create Clone Database wizard.
In the Create Clone Database dialog, select Existing Snapplan The snapplan displays its status. For example, sp00 [init_db] /ora_home/snapplan/sp00, where INIT_DB is the status of the snapplan.
Select a snapplan from the drop-down list with INIT_DB status. The Validate/Modify Snapplan dialog displays with default values set.