Adding and removing systems
This section provides an overview of tasks involved in adding and removing systems from a cluster. For detailed instructions, see the Veritas Cluster Server Installation Guide.
To add a system to a cluster
-
Make sure the system meets the hardware and software requirements for VCS. See the Veritas Cluster Server Installation Guide for details.
-
Set up the private communication links from the new system.
-
Install VCS and require patches on the new system.
-
Add the VCS license key.
See Installing a VCS license
-
Configure LLT and GAB to include the new system in the cluster membership.
-
Add the new system using the
hasys -add
command.
To remove a node from a cluster
-
Make a backup copy of the current configuration file, main.cf.
-
Switch or remove any VCS service groups from the node. The node cannot be removed as long as it runs service groups on which other service groups depend.
-
Stop VCS on the node.
# hastop -sys
systemname
-
Delete the system from the SystemList of all service groups.
# hagrp -modify groupname SystemList -delete systemname
-
Delete the node from the cluster.
# hasys -delete systemname
-
Remove the entries for the node from the following files on each remaining node:
-
/etc/gabtab
-
/etc/llthosts
-
Unconfigure GAB and LLT on the node leaving the cluster.
-
Remove VCS and other packages from the node.
-
Remove GAB and LLT configuration files from the node.
To modify a cluster attribute
# haclus
[-help [-modify]]