Prerequisites
-
Make sure that the applications are not configured in any other service group.
-
Verify the directories on which the applications depend reside on shared disks and are mounted.
-
If the application runs in a zone, make sure the zone is started. Run the wizard on a system where the zone is up.
-
Verify the mount points on which the applications depend are not configured in any other service group.
-
Verify the virtual IP addresses on which applications depend are up. Verify the IP addresses are not configured in any other service group.
-
Make sure the executable files required to start, stop, monitor, and clean (optional) the application reside on all nodes participating in the service group. If the application runs in a non-global zone, the executable files must reside in the non-global zone.
-
StartProgram: The executable, created locally on each node, that starts the application.
-
StopProgram: The executable, created locally on each node, that stops the application.
-
CleanProgram: The executable, created locally on each node, that forcibly stops the application.
-
You can monitor the application in the following ways:
-
Specify the program that will monitor the application.
-
Specify a list of processes to be monitored and cleaned.
-
Specify a list of pid files that contain the process ID of the processes to be monitored and cleaned. These files are application-generated files. Each PID file contains one PID which will be monitored.
-
All or some of the above.