Home > Veritas Cluster Server Manual Pages
HACONF (1M) |
Maintenance Commands |
haconf -dump [-makero]
haconf -help
The configuration file is read-only (by default) upon starting a VCS server on a system. If the VCS server exits without saving the configuration, the configuration is not stale. Use the haconf command to enable modifications to the configuration while VCS is running.
- -makerw
- Change VCS to read-write mode, after which changes to the configuration can be made while VCS is running. This option also marks the configuration stale by creating the file /etc/VRTSvcs/conf/config/.stale on all systems running VCS. The configuration must be written back to disk and made read-only by specifying the -dump and -makero options. Otherwise, the next time VCS starts it waits for administrative action because the configuration is stale.
- -dump [-makero]
- Write the configuration to disk and remove the designation stale. -makero changes the VCS mode to read-only.
- -help
- Display information about this command.
# haconf -makerw # hagrp -modify group1 SystemList -add sysa 1 # haconf -dump -makero
Last updated: April 2006
Copyright ©2009 Symantec Corporation
All rights reserved.