Specifying systems for configuration

The installer prompts for the system names on which you want to configure VCS. The installer performs an initial check on the systems that you specify.

To specify system names for installation

  1. Enter the names of the systems where you want to configure VCS.

    Enter the system names separated by spaces:  [q,?] 
    (galaxy) galaxy nebula
  2. Review the output as the installer verifies the systems you specify.

    The installer does the following tasks:

    • Checks that the local node running the installer can communicate with remote nodes

      If the installer finds ssh binaries, it confirms that ssh can operate without requests for passwords or passphrases.

    • Makes sure the systems use the proper operating system

    • Checks whether VCS is installed

    • Exits if VCS 5.1 is not installed