This section describes how to reattach plexes manually if automatic reattachment feature is disabled. This procedure may also be required for devices that are not automatically reattached. For example, VxVM does not automatically reattach plexes on site-consistent volumes.
When a disk has been repaired or replaced and is again ready for use, the plexes must be put back online (plex state set to ACTIVE). To set the plexes to ACTIVE, use one of the following procedures depending on the state of the volume.
# vxplex [-g diskgroup] att volume plex ...
# vxplex -g mydg att vol01 vol01-02
# vxmend [-g diskgroup] on plex
# vxmend -g mydg on vol01-02
# vxmend [-g diskgroup] fix clean plex
# vxvol [-g diskgroup] start volume