To configure the virtual IP of the cluster

1. Review the required information to configure the virtual IP of the cluster.

2. To configure virtual IP, enter y at the prompt.

3. Confirm whether you want to use the discovered public NIC on the first system.

   Do one of the following:

   • If the discovered NIC is the one to use, press Enter.

   • If you want to use a different NIC, type the name of a NIC to use and press Enter.

   Active NIC devices discovered on galaxy: eth0
   Enter the NIC for Virtual IP of the Cluster to use on galaxy:
   [b,q,?](eth0)

4. Confirm whether you want to use the same public NIC on all nodes.

   Do one of the following:

   • If all nodes use the same public NIC, enter y.

   • If unique NICs are used, enter n and enter a NIC for each node.

   Is eth0 to be the public NIC used by all systems 
   [y,n,q,b,?] (y)

5. Enter the virtual IP address for the cluster.

   You can enter either an IPv4 address or an IPv6 address.

   For IPv4:

   Enter the virtual IP address. Enter the Virtual IP address for the Cluster: [b,q,?] 192.168.1.16 Confirm the default netmask or enter another one: Enter the netmask for IP 192.168.1.16: [b,q,?] (255.255.240.0) Verify and confirm the Cluster Virtual IP information. Cluster Virtual IP verification: NIC: eth0 IP: 192.168.1.16 Netmask: 255.255.240.0 Is this information correct? [y,n,q] (y)

   For IPv6

   Enter the virtual IP address. Enter the Virtual IP address for the Cluster: [b,q,?] 2001:454e:205a:110:203:baff:feee:10 Enter the prefix for the virtual IPv6 address you provided. For example: Enter the Prefix for IP 2001:454e:205a:110:203:baff:feee:10: [b,q,?] 64 Verify and confirm the Cluster Virtual IP information. Cluster Virtual IP verification: NIC: eth0 IP: 2001:454e:205a:110:203:baff:feee:10 Prefix: 64 Is this information correct? [y,n,q] (y)