The following command displays the DMP node that controls a particular physical path:

# vxdmpadm getdmpnode nodename=sdbc

The physical path is specified by argument to the nodename attribute, which must be a valid path listed in the /dev directory.

The command displays output similar to the following:

NAME              STATE    ENCLR-TYPE   PATHS  ENBL  DSBL  ENCLR-NAME
==========================================================================
emc_clariion0_893 ENABLED  EMC_CLARiiON 6      6     0     emc_clariion0

Use the -v option to display the LUN serial number and the array volume ID.

# vxdmpadm -v getdmpnode nodename=sdbc

NAME               STATE    ENCLR-TYPE   PATHS ENBL DSBL ENCLR-NAME   SERIAL-NO            ARRAY_VOL_ID
===========================================================================================================
emc_clariion0_893  ENABLED  EMC_CLARiiON 6     6    0    emc_clariion0 600601601A141B001D4A32F92B49DE11 893

Use the enclosure attribute with getdmpnode to obtain a list of all DMP nodes for the specified enclosure.

# vxdmpadm getdmpnode enclosure=enc0

NAME     STATE    ENCLR-TYPE  PATHS     ENBL    DSBL   ENCLR-NAME
===============================================================
sdm      ENABLED  ACME        2         2       0      enc0
sdn      ENABLED  ACME        2         2       0      enc0
sdo      ENABLED  ACME        2         2       0      enc0
sdp      ENABLED  ACME        2         2       0      enc0

Use the dmpnodenameattribute with getdmpnode to display the DMP information for a given DMP node.

# vxdmpadm getdmpnode dmpnodename=emc_clariion0_158

NAME              STATE    ENCLR-TYPE    PATHS  ENBL  DSBL  ENCLR-NAME
======================================================================
emc_clariion0_158 ENABLED  EMC_CLARiiON  1      1     0     emc_clariion0