If a vxsnap make operation fails during the creation of a full-sized instant snapshot, the snapshot volume may go into the DISABLED state, be marked invalid and be rendered unstartable. You can use the following command to check that the inst_invalid flag is set to on:
# vxprint [-g diskgroup] -F%inst_invalid snapshot_volume
VxVM can usually recover the snapshot volume without intervention. However, in certain situations, this recovery may not succeed. If this happens, the DCO volume must be deleted.
To recover from the failure of the vxsnap make command for full-sized instant snapshots
Use the vxmend command to clear the snapshot volume's tutil0 field:
# vxmend [-g diskgroup] clear tutil0 snapshot_volume
Run the following command on the snapshot volume:
# vxsnap [-g diskgroup] unprepare snapshot_volume
Prepare the snapshot volume again for snapshot operations:
# vxsnap [-g diskgroup] prepare snapshot_volume