To verify Array Support Library (ASL)

1. If the Array Support Library (ASL) for the array that you add is not installed, obtain and install it on each node before proceeding.

   The ASL for the supported storage device that you add is available from the disk array vendor or Symantec technical support.

2. Verify that the ASL for the disk array is installed on each of the nodes. Run the following command on each node and examine the output to verify the installation of ASL.

   The following output is a sample:

   # vxddladm listsupport all

   LIBNAME             VID                 PID
   ===========================================================
   libvx3par.so        3PARdata            VV
   libvxCLARiiON.so    DGC                 All
   libvxFJTSYe6k.so    FUJITSU             E6000
   libvxFJTSYe8k.so    FUJITSU             All
   libvxap.so          SUN                 All
   libvxatf.so         VERITAS             ATFNODES
   libvxcompellent.so  COMPELNT            Compellent Vol
   libvxcopan.so       COPANSYS            8814, 8818
   

3. Scan all disk drives and their attributes, update the VxVM device list, and reconfigure DMP with the new devices. Type:

   # vxdisk scandisks

   See the Veritas Volume Manager documentation for details on how to add and configure disks.