You can configure and administer Veritas Volume Replicator (VVR) using one of the following interfaces:
This topic explains how to set up a Replicated Data Set (RDS) using the command-line interface. VVR enables you to set up replication either when the data volumes are zero initialized or contain valid data. Make sure you follow the best practices or recommendations described to ensure successful configuration of VVR. Detailed examples are also available on how to configure and set up a simple VVR configuration. Read this information before you start setting up replication.
See Examples for setting up a simple Volume Replicator configuration.
Before setting up a Replicated Data Set, decide how you plan to lay out your VVR configuration.
To configure and set up replication, perform the following tasks in the order presented below.
More Information