About using the postcheck option
You can use the installer's post-check to determine installation-related problems.
Note: |
This command option requires downtime for the node. |
When you use the postcheck option, it returns the results of the following commands for VCS and SFCFS:
lltconfig (to check LLT's status)
lltstat -nvv (to check LLT's status)
gabconfig -a (to check ports a, b, and h)
vxfenadm -d (to check fencing)
/opt/VRTS/bin/hasys -state (to check systems' states)
/opt/VRTS/bin/hagrp -state (to check service groups' states)
/opt/VRTS/bin/hares -state (to check resources' states)
See Performing a postcheck on a node.