Removing a persistent dump volume
Warning: |
The system will not boot correctly if you delete a dump volume without first removing it from the crash dump configuration. |
Use this procedure to remove a dump volume from the crash dump configuration.
To remove a persistent dump volume
-
Run the following command to remove a VxVM volume that is being used as a dump volume from the crash dump configuration:
#crashconf -ds /dev/vx/dsk/bootdg/dumpvol
In this example, the dump volume is named dumpvol in the boot disk group.
-
Display the new crash dump configuration:
#crashconf -v
You can now remove the volume if required.