The following command displays the DMP node that controls a particular physical path:

# vxdmpadm getdmpnode nodename=c3t2d1

The physical path is specified by argument to the nodename attribute, which must be a valid path listed in the /dev/rdsk directory.

The command displays output similar to the following:

NAME    STATE   ENCLR-TYPE   PATHS    ENBL    DSBL   ENCLR-NAME
===============================================================
c3t2d1  ENABLED ACME         2        2       0      enc0

Use the -v option to display the LUN serial number and the array volume ID.

DEMC_CLARiiON 6     6    0    emc_clariion0 600601606D121B007C778BC48EDBDB11 162

# vxdmpadm -v getdmpnode nodename=c3t2d1

NAME    STATE    PATHS    ENBL    DSBL   ENCLR-NAME    SERIAL-NO     ARRAY_VOL_ID
===================================================================================
c3t2d1  ENABLED  2        2       0      HDS9500-ALUA0 D600172E015B  E01

Use the enclosure attribute with getdmpnode to obtain a list of all DMP nodes for the specified enclosure.

# vxdmpadm getdmpnode enclosure=enc0

NAME     STATE    ENCLR-TYPE PATHS  ENBL  DSBL ENCLR-NAME
==========================================================
c2t1d0   ENABLED  ACME       2      2     0    enc0
c2t1d1   ENABLED  ACME       2      2     0    enc0
c2t1d2   ENABLED  ACME       2      2     0    enc0
c2t1d3   ENABLED  ACME       2      2     0    enc0

Use the dmpnodename attribute with getdmpnode to display the DMP information for a given DMP node.

# vxdmpadm getdmpnode dmpnodename=emc_clariion0_158

NAME              STATE   ENCLR-TYPE   PATHS ENBL DSBL ENCLR-NAME
==================================================================
emc_clariion0_158 ENABLED EMC_CLARiiON 1     1    0    emc_clariion0