Displaying subdisk information

The vxprint command displays information about VxVM objects. To display general information for all subdisks, use this command:

# vxprint -st

The -s option specifies information about subdisks. The -t option prints a single-line output record that depends on the type of object being listed.

The following is example output:

SD NAME     PLEX     DISK   DISKOFFS LENGTH [COL/]OFF DEVICE   MODE
SV NAME     PLEX     VOLNAME NVOLLAYR LENGTH [COL/]OFF AM/NM   MODE
sd mydg01-01 vol1-01 mydg01 0          102400 0       c2t0d1 ENA
sd mydg02-01 vol2-01 mydg02 0          102400 0       c2t1d1 ENA

You can display complete information about a particular subdisk by using this command:

# vxprint [-g diskgroup] -l subdisk

For example, the following command displays all information for subdisk mydg02-01 in the disk group, mydg:

# vxprint -g mydg -l mydg02-01

This command provides the following output:

Disk group: mydg

Subdisk:   mydg02-01
info:      disk=mydg02 offset=0 len=205632
assoc:     vol=mvol plex=mvol-02 (offset=0)
flags:     enabled
device:    device=c2t1d1 path=/dev/vx/dmp/c2t1d1 diskdev=32/68