Make sure that the Array Support Library (ASL) for the array that you add is installed.
To verify Array Support Library (ASL)
If the Array Support Library (ASL) for the array that you add is not installed, obtain and install it on each node before proceeding.
The ASL for the supported storage device that you add is available from the disk array vendor or Symantec technical support.
Verify that the ASL for the disk array is installed on each of the nodes. Run the following command on each node and examine the output to verify the installation of ASL.
The following output is a sample:
# vxddladm listsupport all
LIBNAME VID PID ============================================================= libvxhitachi.so HITACHI DF350, DF400, DF400F, DF500, DF500F libvxxp1281024.so HP All libvxxp12k.so HP All libvxddns2a.so DDN S2A 9550, S2A 9900, S2A 9700 libvxpurple.so SUN T300 libvxxiotechE5k.so XIOTECH ISE1400 libvxcopan.so COPANSYS 8814, 8818 libvxibmds8k.so IBM 2107
Scan all disk drives and their attributes, update the VxVM device list, and reconfigure DMP with the new devices. Type:
# vxdisk scandisks
See the Veritas Volume Manager documentation for details on how to add and configure disks.