 | ||
| Verifying the cluster nodes | ||
|---|---|---|
| Prev | Verifying LLT, GAB, and cluster operation | Next |
Verify the information of the cluster systems using the hasys -display command. The information for each node in the output should be similar.
Refer to the hasys(1M) manual page.
Refer to the Veritas Cluster Server Administrator's Guide for information about the system attributes for VCS.
Note: |
The example in the following procedure is for SPARC. x64 clusters have different command output. |
To verify the cluster nodes
On one of the nodes, type the hasys -display command:
hasys -display
The example shows the output when the command is run on the node galaxy. The list continues with similar information for nebula (not shown) and any other nodes in the cluster.