PERL5LIB
|
Root directory for Perl executables. (applicable only for Windows)
Default: Install Drive:\Program Files\VERITAS\cluster server\lib\perl5.
|
VCS_CONF
|
Root directory for VCS configuration files.
Default: /etc/VRTSvcs
Note: |
If this variable is added or modified, you must reboot the system to apply the changes. |
|
VCS_DOMAIN
|
The Security domain to which the VCS users belong.
Symantec Product Authentication Service uses this environment variable to authenticate VCS users on a remote host.
Default: Fully qualified host name of the remote host as defined in the VCS_HOST environment variable or in the .vcshost file.
|
VCS_DOMAINTYPE
|
The type of Security domain such as unixpwd, nt, nis, nisplus, ldap, or vx.
Symantec Product Authentication Service uses this environment variable to authenticate VCS users on a remote host.
Default: unixpwd
|
VCS_DIAG
|
Directory where VCS dumps HAD cores and FFDC data.
|
VCS_ENABLE_LDF
|
Designates whether or not log data files (LDFs) are generated. If set to 1, LDFs are generated. If set to 0, they are not.
|
VCS_HOME
|
Root directory for VCS executables.
Default: /opt/VRTSvcs
|
VCS_HOST
|
VCS node on which ha commands will be run.
|
VCS_GAB_PORT
|
GAB port to which VCS connects.
Default: h
|
VCS_GAB_TIMEOUT
|
Timeout in milliseconds for HAD to send heartbeats to GAB.
Default: 30000
Note: |
If the specified timeout is exceeded, GAB kills HAD, and all active service groups on system are disabled. |
|
VCS_GAB_RMTIMEOUT
|
Timeout in seconds for HAD to register with GAB.
Default: 200
See About registration monitoring.
|
VCS_GAB_RMACTION
|
Controls the GAB behavior when VCS_GAB_RMTIMEOUT exceeds.
You can set the value as follows:
Default: SYSLOG
See About registration monitoring.
|
VCS_HAD_RESTART_TIMEOUT
|
Set this variable to designate the amount of time the hashadow process waits (sleep time) before restarting HAD.
0
|
VCS_LOG
|
Root directory for log files and temporary files.
Default: /var/VRTSvcs
Note: |
If this variable is added or modified, you must reboot the system to apply the changes. |
|
VCS_SERVICE
|
Name of configured VCS service.
Default: vcs
Note: |
Before you start the VCS engine (HAD), configure the specified service. If a service is not specified, the VCS engine starts with port 14141. |
|
VCS_TEMP_DIR
|
Directory in which temporary information required by, or generated by, hacf is stored.
Default: /var/VRTSvcs
This directory is created in /tmp under the following conditions:
|