Use the vxdmpadm getdmpnode command to list the devices with less than the required redundancy level.
To list the devices on a specified enclosure with fewer than a given number of enabled paths, use the following command:
# vxdmpadm getdmpnode enclosure=encl_name redundancy=value
For example, to list the devices with fewer than 3 enabled paths, use the following command:
# vxdmpadm getdmpnode enclosure=EMC_CLARiiON0 redundancy=3
NAME STATE ENCLR-TYPE PATHS ENBL DSBL ENCLR-NAME ===================================================================== emc_clariion0_162 ENABLED EMC_CLARiiON 3 2 1 emc_clariion0 emc_clariion0_182 ENABLED EMC_CLARiiON 2 2 0 emc_clariion0 emc_clariion0_184 ENABLED EMC_CLARiiON 3 2 1 emc_clariion0 emc_clariion0_186 ENABLED EMC_CLARiiON 2 2 0 emc_clariion0
To display the minimum redundancy level for a particular device, use the vxdmpadm getattr command, as follows:
# vxdmpadm getattr enclosure|arrayname|arraytype \ component-name redundancy
For example, to show the minimum redundancy level for the enclosure HDS9500-ALUA0:
# vxdmpadm getattr enclosure HDS9500-ALUA0 redundancy
ENCLR_NAME DEFAULT CURRENT ============================================= HDS9500-ALUA0 0 4