This section describes upgrading SF with the Veritas Web-based installer. The installer detects and upgrades the product that is currently installed on the specified system or systems.
To upgrade SF
The installer detects the product that is installed on the specified system. Click Next.
After the upgrade completes, the installer displays the location of the log and summary files. If required, view the files to confirm the installation status.
Perform the following steps only if you upgraded from HP-UX 11i v2:
Reset the cluster-wide attribute "UseFence" to SCSI3 in the /etc/VRTSvcs/conf/config/main.cf file.
If fencing was configured to use the "raw" mode, configure fencing to run in "dmp" mode:
# cp /etc/vxfen.d/vxfenmode_scsi3_dmp /etc/vxfenmode
Set the LLT_START attribute to 1 in the /etc/rc.config.d/lltconf file:
LLT_START=1
# /usr/sbin/shutdown -r now