About preparing to install Oracle RAC
Prev Before installing Oracle RAC Next

About preparing to install Oracle RAC

Use one of the following ways to perform the pre-installation tasks:

SF Oracle RAC installer

The SF Oracle RAC installer provides a menu-driven command line interface to step you through the pre-installation tasks.

Note:

Some of the pre-installation steps are not supported by the SF Oracle RAC installer and must be done manually as described in the manual procedures.

Manual

You need to perform the pre-installation tasks manually as described in the manual procedures.

Response file

You can pre-configure the systems for Oracle RAC installation using an SF Oracle RAC response file. The SF Oracle RAC response file in tandem with the Oracle RAC response files simplify the process of automating and standardizing Oracle RAC installations.

Note:

You can use the response file to automate only those pre-configuration tasks that are supported by the SF Oracle RAC installer.

For instructions, see the chapter "Installing Oracle RAC using a response file" in this document.

The examples in this chapter assume a two-node cluster comprising the nodes sys1 and sys2.

Before installing Oracle RAC, review the Oracle installation manuals and the appropriate Oracle support Web sites. Some of the pre-installation tasks, wherever indicated in the document, must be done in accordance with the instructions in the Oracle installation manuals. The instructions for these tasks are not provided in this document.

Note:

The instructions in this chapter use variables and sample values whereever required. Replace these variables and sample values with values that conform to your installation requirements.

Before you start the preparatory tasks, you may want to update the sample worksheet with the correct installation values and keep them handy during the process.
Prev Up Next
Important preinstallation information for Oracle RAC Home Preparing to install Oracle RAC using the SF Oracle RAC installer or manually