Prechecking your systems using the Veritas installer
Prev Assessing the system for installation readiness Next

Prechecking your systems using the Veritas installer

The script-based installer's precheck option checks for the following:

To use the precheck option

  1. Start the script-based installer.

  2. Select the precheck option:

    • In the script-based installer, from root on the system where you want to perform the check, start the installer.

      # ./installer

      In the Task Menu, press the p key to start the precheck.

  3. Review the output and make the changes that the installer recommends.
Prev Up Next
About Symantec Operations Readiness Tools Home Section III. Installation using the script-based installer