Service group autodisabled


Service group autodisabled
Prev	Troubleshooting service groups	Next

When VCS does not know the status of a service group on a particular system, it autodisables the service group on that system. Autodisabling occurs under the following conditions:

When the VCS engine, HAD, is not running on the system.

Under these conditions, all service groups that include the system in their SystemList attribute are autodisabled. This does not apply to systems that are powered off.
When all resources within the service group are not probed on the system.

Recommended Action: Use the output of the command hagrp -display service_group to verify the value of the AutoDisabled attribute.

Warning:

To bring a group online manually after VCS has autodisabled the group, make sure that the group is not fully or partially active on any system that has the AutoDisabled attribute set to 1 by VCS. Specifically, verify that all resources that may be corrupted by being active on multiple systems are brought down on the designated systems. Then, clear the AutoDisabled attribute for each system: # hagrp -autoenable service_group -sys system

Prev	Up	Next
A critical resource faulted	Home	Service group is waiting for the resource to be brought online/taken offline.