Use the vxdmpadm iostat show command with the -q option to display the I/Os queued in DMP for a specified DMP node, or for a specified path or controller. For a DMP node, the -q option displays the I/Os on the specified DMP node that were sent to underlying layers. If a path or controller is specified, the -q option displays I/Os that were sent to the given path or controller and not yet returned to DMP.

See the vxdmpadm(1m) manual page for more information about the vxdmpadm iostat command.

To display queued I/O counts on a DMP node:

# vxdmpadm -q iostat show [filter] 
[interval=n [count=m]]

For example:

# vxdmpadm -q iostat show dmpnodename=c5t2d1s2

               QUEUED I/Os		    Pending I/Os
DMPNODENAME		READS		WRITES
c5t2d1s2	   	2		   15	          30

To display the count of I/Os that returned with errors on a DMP node, path or controller:

# vxdmpadm -e iostat show [filter] 
[interval=n [count=m]]

For example, to show the I/O counts that returned errors on a path:

# vxdmpadm -e iostat show pathname=c5t2d1s2