To display the multi-pathing information on a system

• Use the vxdisk path command to display the relationships between the device paths, disk access names, disk media names and disk groups on a system as shown here:

  # vxdisk path

  SUBPATH      DANAME     DMNAME     GROUP    STATE
  hdisk1       hdisk1     mydg01     mydg     ENABLED
  hdisk9       hdisk9     mydg01     mydg     ENABLED
  hdisk2       hdisk2     mydg02     mydg     ENABLED
  hdisk10      hdisk10    mydg02     mydg     ENABLED
     .
     .
     .

  This shows that two paths exist to each of the two disks, mydg01 and mydg02, and also indicates that each disk is in the ENABLED state.

To view multi-pathing information for a particular metadevice

1. Use the following command to view multi-pathing information for the specified device:

   # vxdisk list devicename

   For example, the command output displays multi-pathing information for the device hdisk18 as follows:

   # vxdisk list hdisk18

   Device:    hdisk18
   devicetag: hdisk18
   type:      simple
   hostid:    system01
   .
   .
   .
   Multipathing information:
   numpaths:   2
   hdisk18 state=enabled  type=secondary
   hdisk26 state=disabled type=primary

   In the sample output above, the numpaths line shows that there are 2 paths to the device. The next two lines in the "Multipathing information" section show that one path is active (state=enabled) and that the other path has failed (state=disabled).

   The type field is shown for disks on Active/Passive type disk arrays such as the EMC CLARiiON, Hitachi HDS 9200 and 9500, Sun StorEdge 6xxx, and Sun StorEdge T3 array. This field indicates the primary and secondary paths to the disk.

   The type field is not displayed for disks on Active/Active type disk arrays such as the EMC Symmetrix, Hitachi HDS 99xx and Sun StorEdge 99xx Series, and IBM ESS Series. Such arrays have no concept of primary and secondary paths.

2. Alternately, you can use the following command to view multi-pathing information:

   # vxdmpadm getsubpaths dmpnodename=devicename

   For example, to view multi-pathing information for emc_clariion0_17, use the following command:

   # vxdmpadm getsubpaths dmpnodename=emc_clariion0_17 
   
   NAME     STATE[A]   PATH-TYPE[M] CTLR-NAME ENCLR-TYPE   ENCLR-NAME    ATTRS
   ===========================================================================
   hdisk107 ENABLED(A) PRIMARY      fscsi1    EMC_CLARiiON emc_clariion0     -
   hdisk17  ENABLED    SECONDARY    fscsi0    EMC_CLARiiON emc_clariion0     -
   hdisk2   ENABLED    SECONDARY    fscsi0    EMC_CLARiiON emc_clariion0     -
   hdisk32  ENABLED(A) PRIMARY      fscsi0    EMC_CLARiiON emc_clariion0     -