If a vxsnap make operation fails during the creation of a full-sized instant snapshot, the snapshot volume may go into the DISABLED state, be marked invalid, and be rendered unstartable. You can use the following command to verify that the inst_invalid flag is set to on:
# vxprint [-g diskgroup] -F%inst_invalid snapshot_volume
VxVM usually recovers the snapshot volume without intervention. However, in certain situations, this recovery may not succeed. If this happens, the DCO volume must be deleted.
To recover from the failure of the vxsnap make command for full-sized instant snapshots
# vxmend [-g diskgroup] clear tutil0 snapshot_volume
# vxsnap [-g diskgroup] unprepare snapshot_volume
# vxvol [-g diskgroup] start snapshot_volume
# vxsnap [-g diskgroup] prepare snapshot_volume
# vxmend [-g diskgroup] clear tutil0 original_volume