Setting tunables with no other installer-related operations
You can use the installer to set tunable parameters without any other installer-related operations. You must use the parameters described in this guide. Note that many of the parameters are product-specific. You must select the tunables that you want to use from this guide.
See Tunables value parameter definitions.
Note: |
Certain tunables only take effect after a system reboot. |
To set tunables with no other installer-related operations
- Prepare the tunables file.
See Preparing the tunables file.
- Make sure the systems where you want to install SFCFSHA meet the installation requirements.
- Complete any preinstallation tasks.
- Copy the tunables file to one of the systems that you want to tune.
- Mount the product disc and navigate to the directory that contains the installation program.
- Start the installer with the -settunables option.
# ./installer -tunablesfile tunables_file_name -settunables [
sys123 sys234 ...]
Where /tmp/tunables_file is the full path name for the tunables file.
- Proceed with the operation. When prompted, accept the tunable parameters.
Certain tunables are only activated after a reboot. Review the output carefully to determine if the system requires a reboot to set the tunable value.
- The installer validates the tunables. If an error occurs, exit the installer and check the tunables file.