Installer cannot create UUID for the cluster


Installer cannot create UUID for the cluster
Prev	Appendix I. Troubleshooting cluster installation	Next

The installer displays the following error message if the installer cannot find the uuidconfig.pl script before it configures the UUID for the cluster:

Couldn't find uuidconfig.pl for uuid configuration,
please create uuid manually before start vcs

You may see the error message during SFCFSHA configuration, upgrade, or when you add a node to the cluster using the installer.

Workaround: To start SFCFSHA, you must run the uuidconfig.pl script manually to configure the UUID on each cluster node.

To configure the cluster UUID when you create a cluster manually

On one node in the cluster, perform the following command to populate the cluster UUID on each node in the cluster.
```
# /opt/VRTSvcs/bin/uuidconfig.pl -clus -configure nodeA
nodeB ... nodeN
```
Where nodeA, nodeB, through nodeN are the names of the cluster nodes.

Prev	Up	Next
Appendix I. Troubleshooting cluster installation	Home	The vxfentsthdw utility fails when SCSI TEST UNIT READY command fails