To install and configure VCS or SFHA on the CP server systems

• Depending on whether your CP server uses a single system or multiple systems, perform the following tasks:

  CP server setup uses a single system

  Install and configure VCS to create a single-node VCS cluster. During installation, make sure to select all packages for installation. The VRTScps package is installed only if you select to install all packages. See the Veritas Cluster Server Installation Guide for instructions on installing and configuring VCS. Proceed to configure the CP server. See Configuring the CP server using the configuration utility. See Configuring the CP server manually.

  CP server setup uses multiple systems

  Install and configure SFHA to create an SFHA cluster. This makes the CP server highly available. Meet the following requirements for CP server: During installation, make sure to select all packages for installation. The VRTScps package is installed only if you select to install all packages. During configuration, configure disk-based fencing (scsi3 mode). See the Veritas Storage Foundation and High Availability Installation Guide for instructions on installing and configuring SFHA. Proceed to set up shared storage for the CP server database.