Adding the new node to the vxfen service group
Prev Configuring server-based fencing on the new node Next

Adding the new node to the vxfen service group

Perform the steps in the following procedure to add the new node to the vxfen service group.

To add the new node to the vxfen group using the CLI

  1. On one of the nodes in the existing SFCFSHA cluster, set the cluster configuration to read-write mode: 
    # haconf -makerw
  2. Add the node saturn to the existing vxfen group. 
    # hagrp -modify vxfen SystemList -add saturn 2
  3. Save the configuration by running the following command from any node in the SFCFSHA cluster: 
    # haconf -dump -makero
Prev Up Next
Configuring server-based fencing on the new node Home Updating the Storage Foundation for Databases (SFDB) repository after adding a node